Bought a Teflon (PTFE) intake spacer for the intake manifold from Thermatec. It will isolate the intake manifold from the warm engine, which will result in lower intake temperatures. The phenolic spacers are identical in function, only the material used is different.
Lowering the Intake Air Temperature (IAT), will result in higher power figures. A simple supporting mod, which is quite inexpensive.
Pro tip: make a small indentation in the top left corner of the spacer where the bolt would go through the spacer/gasket (where the thermostat housing is), this will make the installation a lot easier due to the restricted space in that area.